![]() It is recommended to use the USB (in DFU mode) for flashing rather than the UART, which is too slow.īelow indications on how to install the USB in DFU mode under Linux and Windows OS, respectively. Ģ.2 Preparing the USB serial link for flashing Details about the content of this tool version are available from ST web site at Release Note.Instructions to follow for using the STM32CubeProgrammer can be found in user manual, UM2237 available from ST web site, or in STM32CubeProgrammer#How to flash with STM32CubeProgrammer article.Execute the Windows installer, which guides you through the installation process.$> ln -s /bin/STM32_Programmer_CLI /home/bin/STM32_Programmer_CLI For example, if "/home/bin" is in the PATH environment variable, run the following command: or once for all by creating a link to the STM32CubeProgrammer binary in a directory already present in PATH.either in each Terminal program in which the STM32CubeProgrammer binary needs to be used, using the following command:.The path to the STM32CubeProgrammer binary must be added to the PATH environment variable.Execute the Linux installer, which guides you through the installation process.Uncompress the archive file to get the STM32CubeProgrammer installers:.Download the archive file on your host PC in a temporary directory.Go on st.com to download the STM32CubeProgrammer software.STM32CubeProgrammer for Windows ® host PC OpenSTLinux generates flashlayout files only for USB programming mode.įor UART usage, refer to Using_STM32Programmer_over_UART article to modify those files.Ģ STM32CubeProgrammer installation 2.1 Installing the STM32CubeProgrammer tool More details on supported Flash memory technologies and mapping can be found in Flash mapping articles, e.g. For example, for the STM32MP157 Evaluation board:ĭuring development, it is recommended to use a microSD card you can then switch to eMMC or NAND Flash memory. The connection between the host PC and the board can be done through UART or USB serial links.Īny Flash device supported on STM32MPU boards can be flashed using STM32CubeProgrammer. Once created, STM32CubeProgrammer allows populating and updating the partitions with the prebuilt binaries. ![]() STM32CubeProgrammer is the official STMicroelectronics tool for creating partitions into any Flash device available on STM32 platforms. 5.7 How to populate a microSD card inserted in a Linux host PC.5.5 How to explore all the partitions of a populated microSD card.5.4 How to find the DEVICE_PORT_LOCATION parameter value for the USB link.5.3 How to proceed when the DFU driver installation fails on Windows host PC.5.2 How to check if the DFU driver is functional.5.1 Where to find the STM32CubeProgrammer user manual.4 How to flash with STM32CubeProgrammer.2.2 Preparing the USB serial link for flashing.2.1 Installing the STM32CubeProgrammer tool.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |